Check Out This Floppy Disk Planter I Made…

**This post may contain affiliate links at no extra cost to you.

Have you ever saved up a bnch of those old 3.5 diskettes that were made in the 90s-early 2000s? If you’re a millenial, you guys probably were on the good ol’ flahs drive, but I digress. I’m talking about what I used to call “three and a half floppies” small diskettes that are about that size. They may be outdated now but I kept a bunch of them as they came in lots of pretty colors and I alway thought there were other uses for them. I’ve made coasters (see “Big Bang Theory” for the first refrnce. They make a good pencil holder too. Now this is something that would be great to do with small plants adn seedlings….Make a few adn transofrm your garden green to a little geek chic.

I first saw a post about it on instructables dot com. This person used glue to seam the diskettes together, but I say unless you’re using a waterproof solvent that’s very thick, I’d avoid glue, it’s messy adn drips, I’m actually using wire to seam the diskettes togeher.

This is small gauge 25 so it’s kind of thin so it will work great for this purpose. Here are all my diskettes spread out, you need 5 for theis project… four for the sides andf one for the bottom.

zif you still want to use glue to attach them togehter make sure you use something like e6000 or you may be disappointed. I’m not sure about Krazy Glue as there’s one type of plastic that it is incompatible with and I know these disks are made of some type of plastic but I’m not sure what its called. Anyway, I have done the next step, I have drilled tiny holes in the top corners. If you look at the bottom of each disketter you’ll notice little teeny square openings. We will be making use of those cutut openings but we need to drill a tiny hole in the top two corners. To protect the plastic outside, I put a piece of tape over the corners. There is always the danger it might shatter so do this to protect it.

Now take 2 diskettes adn use a length of craft wire to thread through the bottom corners and top. You may need to weave it around a few times. To secure it down be sure and take a pair of needle nose pliers and tighten down ro crimp the ends so you don’t get stuck (it hurts, wire is sharp) a loop on the ends will prevent you getting a painful poke. This si how the first should look. Repeat this to join the thrid and fourth disks, then seam them together so it kind of looks like a cube.

Try to make sure the sides don’t overlap. Nw we’re going to attach the bottom. Use some more wire to do this, try to wind the wire aorund the corners as well as the side opening. ALl the bottom corners have this little square cutout so this step should be easy. Make sure they all line up without overlapping.

Now for the use. If you can find a plastic container that is small in the neightborhood of 3.5″ that will fit inside, use it. Be sure to drill a few drainage holes in the bottom adn side for your plant. I am using a tomato seedling that I planted or transplanted, actually, into one of those sundae cups you get from plasces like Dairy Queen. It is okay if the container has a rim that fits on the outside just as long as the bottom diameter and sides degue in nicely.

Now you can use it for small houseplants (wild African violets or succulents come to mind, or seedlings, whatever you have to keep in your home that you enjoy. Don’t forget to water your plant as needed (if you followed the steps correctly there should be drainage holes already on the corners. But you can add a few extra if you want. Also you may want to keep a plate or saucer under it.

Leave a Reply

Your email address will not be published. Required fields are marked *